22mm handlebar mount for Samsung S8 & S10

cults3d

Designed initially for a BMW F800ST, but can be used on any 22mm handlebar, as long as the bar risers are at least 60mm from each other. There is a fixed assembly composed of the following parts : - Bottom shell - Top 1 - Top 2 - Sliding pin - 4mm spring from a pencil You'll need 4* 4x50mm screws with jam nuts The support and the lid can be linked with a 2mm steel wire. The support can be put on the fixed assembly in portrait or in landscape position. You just have to press the support against the handlebar assembly and slide it until the pin pops in the center hole and secures it. All the parts have functional clearances and were printed in PETG. The lid is a bit larger than a standard S8. It is designed to be used with a silicone sleeve. If it's not tight enough, you can add a layer of foam or rubber to it. The S10 being slightly larger won't allow a full sleeve to fit in the support. Only the rubber layer on the bottom. Here is a quick demo : https://youtu.be/LQK17reDv0Y