22RE Engine Mount (with Transmission) Adjusted for Replicator and Clones

thingiverse

The original engine stand modified for a transmission is too wide by a few millimeters to be printed on a Replicator (or in my case Flashforge Creator). I imported the STL into OpenSCAD and sliced off the outer portion of the stand. This shouldn't modify its function by much, only allow it to be printed. The total width is 144mm now, which fits within the 145mm boundary. It is possible the original would print just fine, but I didn't want to waste filament on a test that might fail towards the very end. The bed itself is too small to accommodate the total width, but the model expands towards the top, so it's really limited not by the plate size, but by the travel of the Y axis.