240mm by 15mm Fan Spacer, Split

thingiverse

Expanded the depth to 15mm, which I needed to go from the bottom of an NR200 to 2x120mm fans pushing it right up against my specific deshrouded GPU (Asus 5700xt TUF). Print two of these, and they will slot together. It's *very* tight, I had to use a rubber mallet to get them 90% of the way, and then a hammer with one good smack to make them flush. The holes will line up with 2x120mm fans right next to each other. There is enough room between the top and bottom screw holes to fit a fan screw, and you can screw them into the fans through the hole on other side. The holes are a touch big, so either fill them in a bit or find a good fan screw that can thread them and hold. I had some that worked so I didn't shrink the hole.