28mm Doors - Zombicide

thingiverse

Some doors designed for Zombicide Black Plague but will work with other games like flashpoint. Medieval design along with a more modern version. Door openings are around 36 high x 20mm wide. Base is 28mm square. About 40mm tall overall. Plates and individual pieces are available. Each plate is an entire door. Z1 - Arched block frame door Z2 - Rectangular wooden door Z3 - Arched column door (single opening door) Z4 - Modern rectangular door Z5 - Improved arched column door with 2 opening doors (more pieces) Z6 - Prison/Barred door Z7 - Modern reinforced door Z8 - Modern wooden door Z9 - Modern door Z10 - Modern steel door They use a universal base (except Z5). "Door Base - Dual Hinge" will allow the door to be hung left or right. "Door Base - Small" has a smaller rectangular base. "Door Base - Left Pivot (mirrored)" will allow the door to be hung on the other side of the frame without the extra hole the dual hinge base has. Z2, Z4, Z6, Z7, Z8, Z9 and Z10 use the same frame. Z4 and Z7 doors are identical front and back. Z6 is a single piece door. 13.01.2020 "Door Base - Small" added 19.10.2017 Z6-10 added. Z3/5 base modified 23.09.2016 Z5 dual hinged door added. Z3 fixed 06.03.2017 Z6 door added, parts renamed Print Settings Printer Brand: RepRap Printer: Mendel90 Rafts: Doesn't Matter Supports: No Resolution: 0.25 Infill: 90Deg Notes: Designed for 0.25T x 0.5W but should work for other layer heights. Lots of the features are 0.25 high and a bit over 1mm wide to optimise the amount of detail you can get into a model. I printed infill/top layer at 90 degrees so that it would look more like wood-grain. Post-Printing Glue or acetone (ABS only) the doors front and back pieces together. Insert the door pivots into the frame holes and push into the base. They should fit in snugly, some glue may be required.