2nd Gen Subaru Legacy Rear Speaker Spacers (mounting brackets)

thingiverse

These brackets allow you to install aftermarket speakers into the rear doors of a 2nd Generation Subaru Legacy (1995-1999). The rear doors on this generation of Legacy uses different bolt spacing than all other Subarus. I designed and made these brackets because I couldn't find anyone else that made them for this generation of Legacy. I was able to fit 6.5" Alpine (SPS-610) speakers in the rear doors of my Subaru Legacy using this spacer. Print Settings Rafts: No Supports: No Infill: 30 Notes: no supports or rafts are needed. If using ABS I found that printing with a wide (25mm) brim can help prevent the tabs from warping. I recommend printing with several upper and lower layers and infill of at least 30% since your self-tapping screws will need to bite into this to hold your speaker to the spacer. Post-Printing For installation you'll need to use longer screws than what was used by the factory. You'll also want to use shorter self-tapping screws to hold your aftermarket speaker to the spacer.