3-Spool: Wire spool holder

prusaprinters

<p>I needed something on my wall to store wire spools so that I would have easy access to wire. I made this holder to suit the wire spools that I have.</p><p>The spool holder holds 3 wire spools that measure 90mm diameter and 43mm thick. The diameter of the rollers is 30mm.</p><p>Printing:</p><p>In mine the rollers are printed in black PLA+ and the holder is printed in black PETG (The only reason for the two different materials is that I ran out of PLA+ after printing the rollers.)</p><p>To make sure that the nubbins on the end of the rollers stick firmly to the rollers, I print the nubbin at 100% infill but everything else is printed at 20% infil but I'm sure it would do just fine at 10% or 15% but it just wasn't much extra time or plastic to do 20% and I wanted to make sure the part was strong so I went with that. I used the Gyroid infill don't think there was a reason (I probably should have researched the strongest infill but the parts seem really strong and gyroid looks cool when it's printing :)</p><p>The PETG (Tinmorry) is printed at 240C with the bed heated to 90C<br/>The PLA+ (Sunlu) is printed at 220C with the bed heated to 80C</p><p>After the rollers are printed (They are printed in two halves to save you needing supports) they need to be glued together. I just put a little superglue between them and I clamped them together while the glue cured (just a few minutes). I have tried to break them in half again by hand and I can not, so I am happy with the results..</p><h3>Print Settings</h3><p><strong>Printer Brand:</strong></p><p>Prusa</p><p> </p><p><strong>Printer: </strong></p><p>I3 MK3S</p><p><strong>Rafts:</strong></p><p> </p><p>Doesn't Matter</p><p> </p><p><strong>Supports: </strong></p><p>Yes</p><p><strong>Resolution:</strong></p><p> </p><p>200</p><p> </p><p><strong>Infill: </strong></p><p>20</p><p><br/><strong>Filament:</strong><br/>Sunlu/Tinmorry PLA+/PETG Black <br/> </p><p><strong>Notes: </strong></p><p>The PETG (Tinmorry) is printed at 240C with the bed heated to 90C<br/>The PLA+ (Sunlu) is printed at 220C with the bed heated to 80C</p><p> </p><p> </p><p> </p><p> </p><p>Category: Tool Holders &amp; Boxes</p>