3-way with fuse hub board

thingiverse

请使用google翻译，英文不好，担心可能会造成误导 Thermal head cable management for printers. I will share other board,and this one update in the facebook group: https://www.facebook.com/groups/3228638717201092 国内朋友加QQ群:773223346 It is used for BLV power distribution lines and hubs. Of course, other printers can also be used, but it is more suitable for BLV Including 5v, 12v, 24v, 3 power supplies, each has a fuse, indicator light, and the wiring is very wide, enough to pass the current below 10A, and the sockets are also 10A standard. The resistances of the led are: 2.2kΩ(5v), 4.7kΩ(12v), 10KΩ(24v). The brightness can be seen in the figure. After a long time of testing, there is no problem, the temperature has not risen, and it can be used with confidence. Be careful not to connect the hot bed, the plug may not be able to bear it, more testing is needed to confirm. 3 5v outputs, 3 24v outputs, 4 12v outputs, and 2 12v outputs with switches. These two need to be connected to a metal button switch. The specific connection method is to connect the metal switch as shown in the figure, and then The 3 wires of the switch are inserted into the plug-in board, so that the two outputs can be controlled by the switch. Press the switch and the light is on and output 12v. Press it again, the light is off, and 12v is disconnected. 用于BLV的电源分线，集线，当然其他打印机也可以用，只是更适合BLV 包括5v，12v，24v，3路电源，各自都有保险丝，指示灯，布线都很宽，足够10A以下电流通过，插座也都是10A的标准。 led的电阻分别为：2.2kΩ(5v),4.7kΩ(12v),10KΩ(24v) 亮度如图中所见 经过长时间测试，没有问题，温度没有升高，可以放心使用。 注意不要将热床接入，插头可能不能承受，需要更多的测试才能确定。 3个5v输出，3个24v输出，4个12v输出，还有2个带开关的12v输出，这两个需要接入金属按钮开关，具体接法是将金属开关如图中接入，然后将开关的3根线插入插板，这样就可以用开关控制这两个输出，按下开关灯亮，输出12v，再按下，灯灭，12v断开。