30% Size Cam Clip Using 1.75mm Filament Pieces as Hinge EXPERIMENTAL

prusaprinters

<p>Trying to print the excellent Bag Cam Clip by Andrei at smaller sizes fails for me at the hinge pins. I had the idea to use a small bit of filament instead, so added ~2mm holes.<br/> It's a pretty strong little clip even at this size and is only about a gram of plastic!</p> <h3>Print instructions</h3><p>Use the .3mf if you can, support blockers and settings are already in place.<br/> Otherwise, you'll need support on build plate only and a 0.15mm layer height with decent infill %.<br/> Work a piece of 1.75mm filament - you probably have short pieces laying around you can use - through each of the two holes, and then melt the ends to make a sort of plastic rivet.<br/> I used the tip of a 3d pen but a soldering iron would work too.</p>