3030 SKR V1.1 Enclosure

thingiverse

EDIT 2020/03/10 Addition of SDAccess version, named to allow access to SD card. This enclosure is designed for the SKR V1.1 with ample space around the board for cable management. It was used successfully on a derivative of the I3030 Cartesian printer. The enclosure features two holes for M5 screws to securely mount onto 3030 aluminum extrusions. Cable output holes are strategically placed: * A large hole under the enclosure with multiple holes for zip ties * One round hole for heated bed cables * One angled hole on the upper side for extruder cables at a 45-degree angle * A large hole on the upper side for screen cables The door is securely held in place by three fingers and two M3 screws. Extruder output is designed to utilize 2.5mm nylon, mirroring Prusa's printer cable management technique. A mounting slot for a 40x40 fan is located on the door; it must be installed as an extractor. CAUTION: SD card access is not included in this design, as Klipper Firmware is used.