30x30 VTX03 + micro-camera fpv pod

thingiverse

This is a simple light-weight pod for any 30.5x30.5, for mounting and protecting a micro-camera. There are cutouts in the top for placing a VTX03 on the inside using a zip-tie, and cutouts in the top + rear for routing and mounting the fpv antenna using a zip-tie. Optionally antenna tubes (forever-tubes) can be inserted into the two holes on the sides of the pod, which will make sure diversity antennas have 90 degrees of separation. Note that the pod is optimized for 30 degrees of angle for the camera, although small adjustments up and down are possible. The camera is mounted using two slots instead of holes, that allow the camera to be placed at an optimal depth into the pod depending on lens. I have printed this in nylon for optimal strength and durability, and the weight came out at about 7 grams. It can probably be printed using TPU as well, but I haven't tried it.