35mm Film 4x Canister

thingiverse

This is a Case for four Rolls of 35 mm Analog Film (135). One edge has a cutout so the film fits snuggly inside and doesn't wobble around. It holds rolls with the leader sticking out. Film is not dead!!! Print Settings Printer: Wanhao Duplicator i3 V2 Rafts: No Supports: Yes Resolution: .2mm layer height Infill: 25 % Notes: Support for the Container itself is not necessarily needed. This depends on how well your printer can print the filleted edge on the bottom. My Wanhao did an excellent job at this and i didn't need any support. For the Lid you definitely need support as i recommend printing it facing the bottom down on the build plate so you will get a nice top finish (you will not look at the inside eyh). The Lid fits tight onto the container, the tolerances in the design are 1 mm in the lengthy direction and .5 mm from front to back. If you have too little or too much play, scale the part(s) up or down a tiny bit in the slicer and it should work.