360W PSU Safety cover with fused switch

thingiverse

This is a cover for the wiring that connects to a 360W power supply. The A/C connections are dangerous if left exposed. Since I am planning on placing my power supply outside of the printers enclosure, I wanted to make sure that all access to the wiring and connections to the power supply are covered. The holes in the side for the wiring fits [1/2 Inch Split Loom Wire Flexible Tubing Conduit Hose](https://www.amazon.com/Support-Split-Flexible-Tubing-Conduit/dp/B00U8LA25O). There is also a place to mount either a digital voltmeter, or a volt and ammeter on the front of the cover. The switch is a fused power switch that fits in the opposite side of the cover. Having a fused switch is just another precaution to prevent fire, especially on DIY 3D printers, or cheap 3D printer kits. These power supplies can also be used to power light strips or any other DC device that requires up to 12V to run. **UPDATE:** I extended the slots so they fit a wider variety of power supplies, the other design had them too close together for some PSU's.