3d led printer lamp

cults3d

Hinged lamp for small 12v. led strip to connect to the printer power supply. Cables hidden inside. The "head" is wise to make it out of aluminum or other heat-dissipating material. Take care to insulate the joints and welds of conductive materials. This metal "head" would need to be drilled a couple of holes to allow the screws to pass from side to side. 3mm diameter drill. It is also convenient to make a recess in the edge to facilitate the passage of the cables. To do this, insert this "head" in the corresponding piece and with the help of a marker (pen, pencil, etc.) proceed to mark the points where to work. Then we disassemble and work. There is a base piece to be screwed to some heavy element or fixed site that provides stability to the assembly. A small switch can be attached to it. The switch box provided is for one that cuts both poles (positive and negative). It is a little bigger than the one that comes with the PC power supplies. The latter only cuts one pole (the positive or negative). Before you start printing, check the measurements. ;-P