3D Printed Whirligig

prusaprinters

<p>This is a whirligig that I had made a few years ago out of wood. I decided to try making it again, this time 3D printing the parts.</p> <p>The Assembly_guide.png file will show how it goes together. Once the model is glued and the hardware attached, find the balance point and glue the swivel with attached rod to the base at that point. This location could vary depending on the type of plastic, hardware, and scaling you may have used.</p> <p>I've posted a short video showing action.<br/> <figure class="media"> <oembed url="https://www.youtube.com/watch?v=B7xo6ONpo9A&amp;feature=youtu.be"></oembed> </figure> </p> <h3>Print instructions</h3><h3>Category: Interactive Art Print Settings</h3> <p><strong>Printer:</strong> FlashForge Creator pro</p> <p><strong>Rafts:</strong> Doesn't Matter</p> <p><strong>Supports:</strong> Yes</p> <p><strong>Resolution:</strong> .2mm</p> <p><strong>Infill:</strong> 15%</p> <p><strong>Notes:</strong></p> <p>Materials needed</p> <ul> <li>4 - 608zz skateboard bearings - $5.45 on amazon</li> <li>1 - length of either 5/16 or 8mm threaded rod</li> <li>10 - 5/16 or 8mm nuts </li> <li>6 or so 8mm washers</li> <li>2 - 6-32 or m3 X1 1/4" or 30mm screws </li> <li>2 - nuts for above</li> <li>1 - 1/4-20 X 1 1/4" or m6 X 30 screw</li> <li>3 - nuts for above</li> <li>a short length of stiff wire for eccentric (I used 2mm steel wire) </li> <li><p>2 short lengths of thin wire for the hind leg kicking action (I had some .8mm wire on a spool that I used)<br/> On my prototype, I used a 10-24 internally threaded X 1/4 in diameter<br/> tube with a 10-24 standoff and washer instead of the 1/4-20 screw and nuts.<br/> Don't know the exact terminology, but found them at Ace Hardware. I think<br/> they are used to join cabinets or furniture.</p> <p>I made sure everything turned freely, then put a drop of super glue on all the nuts to lock them from loosening.</p> </li> </ul>