3DR Quadcopter moon shoes

thingiverse

Padded landing feet for 3DR quadcopter frame Instructions Cut a short piece of 50mm OD pipe insulation tube and hot-glue to base of feet for padded landing feet, aka moon shoes. --UPDATE-- I've found the original feet had some problems. 1) Screw hole was too low. You could get the screw in through the leg, but it went in at a slight angle. This was nice because it made for a nice tight fit, but it also put some pressure on the plastic that would cause failure. This screw hole has been moved up a bit. The area surrounding the screw hole has also been 'embiggened' to add a little more meat. 2) The base was too thin and could crack on hard landings or crashes. The base has been thickened. If you want these fixes download the robusto_2 .stl or .scad.