40mm Blower Fan Adapter for Briss Fang

thingiverse

I print in PETG quite often and found the 40mm fans the fang was designed for gave to much air flow even dialed right down to print PETG. So I made an adapter for the stock 40mm blower fan that can be quickly installed when I want to print PETG. It works very well. I have no issues printing PETG with the Fang now. Prints in 2 pieces, the main body of the adapter and the top cover for the air duct. Simply glue the cover to the main body. I made it this way to eliminate the need for supports and keep the duct lines nice and clean. You will need to mount the adapter to the fang before attaching the blower fan as 2 of the mounting screws are located under where the fan mounts. Requires 4 M3x8mm screws to mount the adapter to the fang. Uses the stock screws for the blower fan. I printed in PETG to match the Fang I printed but PLA is a reasonable choice as there is no heat issue where the adapter is mounted. Hope this is of use to some body.