45° LED Strip Mounting Brackets for IKEA Lack Enclosure (and other uses)

prusaprinters

<p>I wanted to add some lighting to my IKEA Lack Enclosure and decided to go with some LED strips from Amazon. I also wanted to angle these so that they pointed towards the printer, even those mounted on the under side of the lid when it was open.</p> <p>These strips have pins and sockets in the ends to help with aligning them in a straight line. I also had a section where I wanted to hide some wires, so I added an internal channel for wire management.</p> <p>There's probably a better way to do this, but I created a model for each length of the strip from 1 cm up to 20 cm so they could easily be mixed and matched for the overall desired length.</p> <p>These should be able to handle LED strips as wide as 14mm. There are many options out there to choose from. I ended up using these LEDs from Amazon for my enclosure and had several feet left over when I was done. <a href="https://www.amazon.com/gp/product/B07PLZ385X/">https://www.amazon.com/gp/product/B07PLZ385X/</a></p> <p>I also created a wire grommet to cleanly pass the power cable through the base of my Lack Enclosure. The end of the LED strip power plug was a tight fit and took a little force to push it through the grommet. See this print for details <a href="https://www.prusaprinters.org/prints/31922-cable-management-grommet-for-ikea-lack-enclosure-1">https://www.prusaprinters.org/prints/31922-cable-management-grommet-for-ikea-lack-enclosure-1</a></p> <h3>Print instructions</h3><p>These are the settings I used for my prints.</p> <p><strong>Resolution:</strong> 0.20mm Quality<br/> <strong>Material:</strong> PETG<br/> <strong>Supports:</strong> None<br/> <strong>Infill:</strong> 15%<br/> <strong>Brim:</strong> None</p>