49mm Lens cap with more grip

thingiverse

This is a remix of the lens cap by elenaut. All credit to him. I printed his design but it didn't fit on my lens so I changed a bit. I made the edge, that goes inside the lens longer so it has more grip and holds better onto the lens. You might not need my design but some lenses are built different. The spring needs to print upside down and needs some support but I recommend to make custom supports so you don't have to remove supports inside the finger-holes. The base part can be printed normally without support or any changes. When putting together the parts you might need to snap the middle walls to get the spring in position but try just to bend them and bend them back when finished so it doesn't separate when in use.