$5.00Propeller, Turboprop-2

myminifactory

This model is the propeller for model of “Turboprop Engine, RGB separation type”. A. The following explainable elements were incorporated.(1) Blade with Cuff (x4)(2) Pitch Change Method Bevel Gear type, Changing by turning “Front Cone”(3) Pitch Stop There are 2 stops (Reverse and Feather).(4) Pitch can be changed by turning of Front Cone. B. Assembly Manual (PDF format, total 9 pages)The detail assembly manual including "Parts-List", "After printing treatment" and "Assembly procedure" are prepared based on "Standard Skill (Filing, Drilling, Tapping, gluing and tightening)". C. General Notes 1. No Metal Bearing is used. 2. Drill and Tap My design hole diameter is considerably smaller than the finish hole diameter in order to ensure the wall thickness at the time of printing.Drill : φ1.5, 2, 2.5, 6.2 Tap : M2, M3For M1.4 Screw; No need “Tapping”. Drill with φ1.0 drill then direct screw-in. D. STL files Files: STL Files (13 items) “ws” of last 2 digits means “With Support” special designed. E. Total Net Print Time: Approx. 19HR (Estimated as case of PLA, 0.4mm Nozzle, 0.2mm Layer Height, 40% infill and No raft and support) Note: When at actual print, each parameter may be adjusted by your experience. F. 3D printing settings Raft, Support, Layer Height, Infill: Depending on your experience. My models were printed by "idbox" using with 0.4 nozzle, 1.75 PLA.