5.25" Half Height Bay Gotek Floppy Emulator Bracket

thingiverse

* Added a new version that fits an OLED with a 28mm wide PCB (called 27mm due to typo), default version is 26mm wide as per the OLEDs I have Final design and taken out of WiP. Have gone with the 2 hole version as it fits better in most cases, just having the one bottom hole meant on some cases it would be recessed to much. Have kept bezel and non-bezel versions. I've ordered some 1.3" OLEDs and will put a new design up once I've tested those. For now this only works with the 0.96" 128x64 OLEDs. WiP text below for reference... This is a WiP design to fit a Gotek drive in a half height 5.25" bay. Subject to change Space for a rotary encoder & 0.96" 128x64 OLED display which just slides into place and holds well * v2 is 2mm deeper/longer as I found two versions of the 5.25" half height specifications on the web so need to test further. * After printing v2 it is too short for modern PC cases, so a new version for these cases has been added. This version the holes are 52.75mm from the front, basically added 5mm for the bezel. I recommend this version unless you know your case is shorter * Added a new version with two sets of holes on the side to help with case mounting * Added another new version with a front panel Bezel (sides only) * v2 Bezel added, no extra width and slightly thicker for better printing