58mm swiss army knife scale w/ holes for tweezer, toothpick or pen

thingiverse

I decided to remix this to see if I could get the edge contour closer to the original. After a couple tries, I think I got it! I also cleaned up some of the internal lines. In order to attach it to the knife, I used paper on either side and used channel-lock style pliers, but a vise would also work, just use something to got between the tool and plastic to prevent marring. Important, make sure to rotate in your slicer to print flat side down. I used supports and printed at 100% infill for strength. Note: for the Pen side, there is a small build in support that should come off easily. This will ensure that the lock stub prints strong enough.