5MM LED Holder for PCB

thingiverse

This is a 5mm LED 90* holder for mounting on a PCB (Printed Circuit Board). It will hold the LED once you push the LED into the socket and bend the leads over at a 90* angle, The holder can be inverted to adjust the height of the LED off of the PCB as needed. This was printed at 100% infill and no supports but I did put it on a raft (printed 4 at once) beings it was so small and needed the extra area to provide a vertical support as ti was printed. I had no issues with printing this in ABS, 100% infill, no supports, on my FlashForge Creator Pro. The LED socket was a little tight (wanted it that way) to hold the LED in place while I bent the leads over on the back, depending on your printer you may have to clean out the socket and or the lead holes in the back of the socket. Hope this design is helpful for those that design and or make PCB's for projects.