6' x 6' Robot Combat Arena

thingiverse

This is the CAD for my 6'x6' combat robot arena. This arena is built using 2"x2" tubing (11ga) and 7/16" Lexan panels. All hardware is 1/4" and is not shown - if you see holes, use bolts through lexan. Also not shown are weldable hinges and door closure - this is beyond my current Fusion 360 skill level. This arena is mounted to a modified 4'x8' trailer. My original plan was to make it "collapsible" by having the four upright 2"x2" tubes nest into the top/bottom using 1-3/4" tubes (interference fit with pin to secure). However we have multiple venues with roll-up doors where we can pull a trailer in and go, which is so much easier than tearing down and setting up. My BOM and expense list are here: https://drive.google.com/open?id=1dvoz7tIKqV35QA1j574p_zdFiPyjzuyK-7oKNTSuEWI Our Facebook page is here: https://www.facebook.com/angryroosterrobotics/ Sparc.tools arena construction best practices: http://sparc.tools/wordpress/wp-content/uploads/2016/10/SPARC_Arena_Construction_Best_Practices_v1.0.pdf I know I am somewhat sparse on details but if you are active in combat robotics and wanting to build an arena, well, you probably have some idea of what you are getting yourself into