64oz Hydroflask Handle and Rings

prusaprinters

<p>Rings print with no supports. Handle can print without on a dialed in printer, however, adding supports only means you need a little clean up if you want that assurance of no dangle strings.</p><p>Multiple sizes available to accommodate slight variations and if you want to use a TPU boot.</p><p>If you use a TPU boot, then you'll want to print one larger ring that grips onto that.</p><p>&nbsp;</p><p>Note: &nbsp;Don't over-tighten the screws or you can add unnecessary stress risers in the ring. Tighten until the handle is secure, but no further. I had a handle break due to over-tightening.</p><p>&nbsp;</p><p>&nbsp;</p>