69 Mustang Tach POD
thingiverse
This is a POD for a AutoMeter Mini Tach 2 1/16". It includes an area for the upper light fixture and allows the 2 bolts to slide through at the rear..... This requires a 1/8" Foam to be added to the the part that goes around the column, this is to prevent scratching and should also allow it to be fixed with out much movement I used https://www.amazon.com/dp/B07RYW3Q46 <b>I have added 3 versions:</b> <b>RivNUT</b> - This version you use a 10-24 rivnut into the hole at the bottom of the top half and glue it in...It fits without the glue and seems pretty snug but glue it in just to be safe. I use a 3/4" bolt/screw <b>Bolt Setup</b> - This one is made so you can use a bolt and nut to hold it together <b>Capture Nut</b> - Allows you to use a 1/4" bolt and and insert a nut into the back of the bezel. Nut should be flat to each side to be centered properly. Works good with https://www.amazon.com/dp/B07TJN6L2J ***bottom-riv just has a smaller hole as i found the rivnut bolt was smaller but either can be used
With this file you will be able to print 69 Mustang Tach POD with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on 69 Mustang Tach POD.