8BitDo Lite 2 Controller Case

prusaprinters

<p>This case was made to fit 4 of 8BitDo's Lite 2 controllers together with their charging cables.</p><p>The dimensions of this case are: 19.3 x 10.5 x 7.4 cm (L x W x H)</p><p>All parts of this model are single color prints which are glued together.&nbsp;</p><p>I suggest printing them with a .6 mm nozzle at .3 mm layer height for most of the part, but a slightly lower layer height at the bottom of the part to get a nicer fillet.&nbsp;</p><p>There is a spot for 8x 5x5mm round magnets in both the bottom and top inside parts, which makes 16 magnets in total. These have to be inserted during printing to make them invisible.&nbsp;</p><p>I stacked 2 magnets on top of each other for every hole to make them stronger so that the lid stays on the case reliably.</p>