96-Hole Earring Holder Stand

thingiverse

I was in need of an earring holder and since I have this handy 3D printer, decided to make one. I found a couple on Thingiverse, but they were too large. I have a small FlashForge Finder printer and needed something small enough to fit on my print bed. I designed two different versions using Tinkercad. (I will load the other version next.) This is very basic, but it does the job. It is printed in two parts. The part with the holes just barely fits on the plate and I printed it without any brim. Make sure your bed is level before printing this. It is very thin, and would be prone to warp up (but it is sturdy enough to hold earrings). Mine did warp very slightly on one corner, but not enough to keep it from "working".