AAA battery holder 2, 3, 4, 5, 6 & 7 stages center split

thingiverse

This is a pre-configured and compiled output from a customizable design for those that prefer set designs. The customizable version can be found at: https://www.thingiverse.com/thing:3395341 This version is configured for: AAA Batteries 2, 3, 4, 5, 6 or 7 Layers (each design has 2 halves R and L) Center split these have been rendered with a very high number of faces to give smooth curves, this gives results which are nicer than the customiser version. These took several hours to render but look nicer than the customiser output. The center split version so does not require supports to be printed but is more difficult to glue the 2 halves together, before adding any glue test fit the 2 parts and make sure they are not too tight (sand the parts down a little if needed) and be careful not to put too much glue in as surface blobs can interfere with the smooth path of the batteries. For the avoidance of doubt, print with the halves orientated so that the solid side is facing down!