ABR-3M

thingiverse

Remixed the ABR-3 into what I now call the ABR-3m The one picture of a printed 3M, print is awful I know - bearing failed on Titan aero, decided I would push through and finish anyway to verify part fitment. Split Shell into 3 (edited - was 2 now 3) pieces, so they fit on a CR10S vertically or horizontally, screws together rather than glue joints, barrel section provides cantilevered support to split. Rear and Middle shell should be printed stood on rear, you may need a bit of brim. Front should be stood vertical on end. Reworked the barrel assembly so it used about 60% less plastic. Designed to use a 3/4" PVC barrel, rather than the original printed one. Replaced the original flywheel cage with a OFP stryfe derived cage. Rotated the guide to suit the horizontal orientation. Should allow a Ultrastryfe cage to fit as well. Increased the width of the flywheel housing to accommodate, added some fillets to round it out more make it match the rest of the P90 body. *** this is a work in progress *** Update 12/30/2018 Split into 3 pieces now. the excessively long rear body interfered with my overhead spool, it was easier to cut the stock than rework the spool mount :) Made a few Fixes along the way, extended front of front shell to end. There is a front carry handle & low poly pic rail coming (see reddit for pictures) - more like the Fortnite P90 or a tactical version. But I'm switching back to my hand-cannon project now that parts are on-hand, so may not be coming quick. Update 12/16/2018 Found glitch in the matrix, reworked front shell a bit - rounded barrel support at front was omitted from original export due to PEBKAC error.