active cooled housing for Raspberry Pi 3

thingiverse

Finally, the case is complete! But wait, it's not displaying properly. I was so focused on getting the raspi-board working that I didn't notice the displayboard is slightly larger than expected. Maybe a few tweaks and some careful edge grinding will fix the issue. This case is designed to work with a Sunon 30x30 5V fan. The upper side of the case will be added later. I've set up the fan to blow air out of the housing and soldered it to the bottom side of the Pi on the 3.3V pin. However, my display blocks this pin, so I chose a different route. There are openings in the housing where air can flow through the heatsinks of the chips. This case is also designed to work with a 3.5-inch display. The four pins reach through the mounting holes of the raspi up to the display, serving as a support. No screws have been needed so far. Resolution: 0.1 Supports treestructure in Cura