Active Cooling Fan Duct for Flashforge (/Replicator1 / Duplicator 4)

thingiverse

This is a remix of http://www.thingiverse.com/thing:295317 I wanted to fit in a 60[mm] fan to have a similar airflow at lower RPM which results in lowered audible noise and lowered vibrations. Do note that depending on your 'homing' settings this MIGHT hit your enclosure, so measure that if possible. If there is a high amount of request I could also design a version for a 50[mm] fan. Use these brackets: http://www.thingiverse.com/thing:350649 Check instructions for additional information. Leave a comment if any questions remain. Instructions Print it in ABS with a 0.2[mm] layer height. 2 shells with a 0.4[mm] layer width. Fan-mounting-area face-down. No supports needed, easy print.