Adafruit Current Sensor INA219 Housing
thingiverse
This is a housing component designed to hold the Adafruit INA219 Current Sensor. It is intended for use on FTC robots. It is recommended to use 2-56 screws to secure the circuit board to the housing. If you printer makes holes slightly smaller, you should be able to put threads into the mounting holes. The outer mounting holes have 8mm spacing and are designed to use 6-32 screws. Again, the holes might be too small, so you can frill them out with a #27 drill bit to create a through hole (or create threads). Print Settings Notes: Supports will be needed for the gap in the middle. Accidentally modeled up-side-down, so flip it 180 degrees.
With this file you will be able to print Adafruit Current Sensor INA219 Housing with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Adafruit Current Sensor INA219 Housing.