Adafruit FeatherWing OLED Cover w/ Buttons

thingiverse

This is a custom cover for JaY_III's Adafruit Feather Case to accommodate an Adafruit OLED 128x32 FeatherWing (Prod ID 2900). This allows you to add a display and control buttons to an adafruit processor board. It includes four 3D printed, two-piece buttons to access the reset and the three mini tactile buttons on the FeatherWing. You must stack the boards using the Adafruit Short Feather Headers (Prod IDs 3002 and 2940) so they will fit in the case. The buttons are intended to be a press fit but you may need to hand ream the mating hole in top part with a 5/64 drill bit depending on your printer. If you do not need all three buttons, a #2-56 nylon flat headed screw and nut works quite well for the buttons instead but you cannot put three next to each other to access all three buttons. The cover is secured to the bottom with #2-56 x 7/8 inch screws and nuts. I prefer the hex head on the top and the nuts on the bottom. (I don't know why thingiverse insists on turning my pictures upside down.)