Additional Face shield with added protection

thingiverse

**Here is an updated version of Part1 of my face shield design, with added protection** I thought best to add this as a remix, as it is more of an alternative version to the original rather than a brand new design, with the added protection with it being both slightly wider and having the top and bottom two layers made solid. The same lattice structure is still the core of the design though, and the original **Part2** will still fit this design. ***Link to original https://www.thingiverse.com/thing:4275083*** This only adds a couple of minutes more in print time compared to the original too, so gives you that added protection of having a solid covering above, without taking much longer to produce. ***Please note:*** This design can also be stacked similar to the original design, however this is not quite as easy to accomplish with the solid top and bottom layers as it was with the open lattice design. Also when importing the stl you may get a repair error, but no need to worry its only due to the new version being made up of three objects, and it will still print just the same. This also gives you the freedom to change the thicknesses of the top and bottom layers, depending on your print settings. **Print Settings:** Layer Height: 0.2mm (***Please note:*** design may need to be adapted if intending to stack prints with thinner or thicker layer heights such as 0.4, 0.6mm etc.) Infill: 0% Perimeter Shells: 1 Top & bottom solid layers: 2 I have decided not to remake the instructions for this additional version, as fundamentally it is the same with just the added protection, therefore please see the original instruction page detailing how to put together. Also, the original **Part2** stl files are still interchangeable so I wont re upload those here just the files with this new version. **Any questions just ask, and feedback as always is most appreciated**