AdimLab Gantry Single Unit Refactor

cults3d

This reconfigures the AdimLab Gantry printer to be a single unit instead of having a separate control box. This configuration turns the printer sideways allowing better clearance when backing the printer against a wall. (the bed goes side to side rather than front to back) The standoffs for the controller are designed for M3 screws. They will break if you over-tighten. Stop tightening when you feel any resistance. I replaced the red/black wires connecting the controller and power supply with standard 120v power cord because they were too short for the new configuration. The controller box connects to the front-underside of the printer, the power supply to the rear-underside, and the interface to the right side. See pictures.