Adjustable Raspberry Pi & Camera mounting solution for Prusa i3

thingiverse

I needed a good solution to mount my raspberry pi and camera to my Prusa i3. I adapted an existing pi mount that I found was not strong enough and kept breaking after printing, and also added an adjustable camera arm that clips onto the frame, based on an adjustable fan duct. Openscad files are provided if you need to tweak anything. Instructions You will require 2 * M3 screws 12mm long or longer. Print all of the stl files or adjust and re-export in openscad. Note: The mounting clip (clip.scad) will probably need support enabled and some cleanup after printing unless your bridging is super awesome. Assemble the camera arm before putting in the camera to avoid damaging the ribbon cable. You may need to slightly cleanup the pins on the camera case so they fit through the circuit board.