Adjustable RC Car Stand w/ Shocks Station

thingiverse

This is an *RC Car Stand* that I built to work on my Traxxas E-Revo 1/16 (it's sized so that it fits the MERV perfectly, but should be able to hold larger models as well). **Features:** * Freely rotating (360 degrees) * Adjustable height (turn the M20 nut to lift / lower - independent of rotation) * Hole sets (4) for holding shocks: 10mm, 13.5mm and 15mm * Holes to hang shocks upside down for draining oil (placed above oil trays for dripping) * Multiple trays for holding parts (including one separated for front / back) * Depending on your printer and settings, prints in around 15h and uses about 140g of filament (which brings cost at about $3, so much cheaper than ordering, including AliExpress) I used some strips of rubber I had laying around for stability, and you can use furniture feet stickers from any DYI store as well.