Adjustable Showerhead Holder

prusaprinters

<p>My old showerhead holder wasn't doing its job anymore so I designed one to be 3D-printed.</p><p>This is designed to fit a <strong>25mm Pipe.&nbsp;</strong></p><p>It consists of 4 parts, is adjustable and easy to print. No suports needed, no adhesives and no screws, that could potentially rust.</p><p>While the the force on the shorter screw determines how strongly the clamp attaches to the 25mm pipe, the longer screw does NOT need to be tightened for a stronger hold! Loosen the longer one a bit until the teeth disengage, choose your angle and then only tighten until the teeth reengage again.</p><p>Print Instructions:</p><p>I used ABS. ASA and PETG should work too. No guarantees on PLA, might be too stiff.</p><p>I used 3 perimeters and 20% Gyroid infill. No need to go crazy.</p><p>Do the overhangs slow, or use smaller layer height.</p>