Adjustable Y-Axis Mod

thingiverse

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/0zhTeNe7oXM This is a mod of bringho's adjustable x axis extension, thing:236933. So many people worry about extending the x axis on the printrbot they forget you can also do the same for the y! As such any extended plate/heatbed will need the proper support. You'll need longer screws to hold the y extension mod in place. This mod allows you to nearly double your y axis, or at least give your wider bed more support on the y axis depending on your setup. I haven't printed all of these myself yet. Edits: The V2 of the adjustable mod is simply rotated so that they can be printed within a 4x4in or 100x100mm square of space, so the original printer dimensions can handle it easily without hassle, and even allow for trim given proper spacing. The Beefy mods are because I found that the original was a little thin, and didn't want to hold up the board and glass bed. These are also rotated to fit within the original space but trim will be tight. Allow zero space between trim and piece and no more than two loops outward. The Thick left/right extended v2 editions will need to be printed on a previously extended axis and will accommodate the MK2 boards. I think past this people should look into printing the Maker's extension that iamjonlawrence has already created that spaces out the rods themselves. I've printed a previous version and they came up a tiny bit short and wanted to warp the MK2 board, hopefully these are just right. The spacer is incorporated into this piece, one side of the actual bar clamp section intentionally short to make adjustments to z-height.