ADONIT MARK STYLUS HOLDER

thingiverse

This is a 1 or 2 part stylus holder for the ADONIT MARK stylus. I just use the open part, ...holder B and it works great. i printed in PLA at a layer height of 0.2 mm, 3 outer layers on all sides and 20% infill. Both parts have chamfers on their ends to prevent "flash" when the first layer is squished onto the print bed.Without the chamfer, the hole would have to be trimmed due to it being too tight from the first layer of printing. You may be able to use one or several of the open mount or one of the open mount and one closed mount to secure your stylus to your table. The parts should be printed with their ends down to ensure the filament runs across the parts for strength during use. They can be attached to the backside of the iPad or other tablet as a foot to angle the device. You would need two of the tallest ones you use so it does not wobble. They can also be attached to the cover. Attachment could be with 3M strips, double-sided tape, or a flexible adhesive.