Adventurer 3 : Bed leveling clip

thingiverse

Adventurer 3 : Bed leveling clip One of the best thing and the worst thing about the Adventurer is the bed which doesn't' needs to level, which is good, however, many users found that the bed doesn't level at all which is due to the bendable plate which causes the un-level, also the tiny parts which holds the Plate will slowly be grinned by pulling the plate in and out from the bed holder. so Hopefully these clips I made will help to level out the damaged holder on the Bed. These clips are the same height as the original Bed Holder, so when you put them on, it will hold the plate with the same height as when it's new. Clips will block the Fan Duct on the extruder, so either you'll have to use the Raised version of the Airduct from Thingiverse or print within 15*12 Always Bend the Plate until it's Flat before putting it back to the Bed, well at least it's Flat to the eye is good enough I did a test print (the first photo) printed with 0.2mm single layer, there's still a tiny bit of difference but it's a good start and it's good enough for me will post the link for download later, if you're interested :)