AEG dishwasher lower basket wheel and hub

thingiverse

Hub and wheel for AEG (an similar) dishwashers. Replaced the flimsy clip function with a more robust design that is reinforced by a end-piece. Wheel and hub must be printed as one piece. The wheel can not be clipped on afterwards. The end-piece is printed separately. Should be printed in ABS or a similarly heat-resistant plastic. I tried both PLA and PETG, but both deformed during the wash cycle. If it is too hard to clip directly onto the dishwasher basket, try to "break it in" first using for instance a screwdriver. I found that the ABS became much more flexible once this was done.