Aero Garden Elite Tower

thingiverse

I recently purchased an Aero Bounty Elite Artisan that came with a seed starter accessory. However, to use the seed starter you needed to take the water pump assembly off the main unit and reattach it to the seed starter tray. These are made of injection molded plastic and are held on with plastic tabs. I am concerned about breaking these tabs over time when going between seed starting and plant growing (taking the water tower off and on repeatedly when switching between units) There are three files. The "Unit" file is the tower and base combined and needs supports to be printed. The other two files are the separated "base" and "tower" that can be flipped and printed without need for supports and should fit together just fine. This was a quick fix to a problem I needed to solve right away. So I decided to shorten the tower assembly to fit just below the spring tabs (thus the four tab holes are not in this design) The unit sits on top of the water pump platform without the need for tab capture holes. So you will need to use the original water pump base and it will slide into the 3D base.