Aero Vortex Motor Generator - Concept 3D model

cgtrader

Aero Vortex Motor Generator - Concept One could put pressurized air into the inlet, creating pressure, building up inside the sideways nozzles, letting the pressure out through a directional hole, one that can turn the entire core of the motor/generator. a gear system can be created by inserting three spheres fixated on an axis, with the diameter of the center axis cylinder, pulling them in the junction allows for flow to pass through, pulling them, back outward, blocking off passages to the inner and middle rings, the smaller gears so to speak. the turning rings are of course fitted with magnets that we can use to create more motion, or use to create electricity. effectively turning motion from air pressure into electricity, or air pressure into a spinning axis. if all 3 rings are open, air flows through all three rings, if we close the inner ring off, more air pressure will be available for two rings, creating more speed after the initial start up, or gear 1. block off the inner and middle ring for yet another gear, now receiving all of the air pressure pushing itself around a center axis, creating spinning motion we can use to generate as well. i have placed the center core ring magnet, in a certain alignment, but different alignments are possible by allowing it to turn around the center axis as well. i have create air outlets, inside the windings, so air can escape the spherical hull of the motor, is pushed downward by the shape, downward, following the spherical shapes outer curves, cooling the entire hull and electronics inside. the entire engine can be and is split in half, for easy 3D printing and easy assembly. just fit two hemispheres together to connect the two engine halves. the twisted core vortex shape allows for a evenly spread of air flow and stimulates the turning motion.