AeroPress universal mountable drying stand

thingiverse

Finally, a convenient place to put my AeroPress! This mountable stand holds the AeroPress with the filter-cap sitting below to dry. We have ours attached using double-sided tape behind and above the sink. The mounting options allow for your choice of double-sided tape, magnets, or screw mounts. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 3 Rafts: No Supports: No Resolution: 0.15 Infill: 15 Notes: Model was design to print without supports.... some cleanup may be needed for the magnet/screw brackets. Two versions: Universal mounting-options (places for magnets, screws, or use double-sided tape) Double-sided table only (no mounting/magnet holes) Instructions Print with 15% infill or greater. Optional: If using food-grade PLA you can also anneal the print afterward. Double-side Tape Mount Use your choice of double-sided tape or adhesive/velcro Magnetic mount Insert 4 12mm x 4mm neodymium magnets into the holes in the back (I used N48 magnets) If your mounting surface is slick your may need to add a rubber coating to the magnets (such as Sugru or a layer of rubber cement equivalent) Screw Mount Use screws with heads at least 5 to 14 mm wide, no more than 4mm deep or use a suitable washer. Two screws are probably sufficient, but 4 screw holes are provided