AIO FPV Cam Mount for Tinywhoops

thingiverse

Hello! This is my very first project ever in modeling. Using blender. Printing. The whole shabang. I recently built an acrowhoop (Tinywhoop, Inductrix, eachine) and wound up purchasing a Crazy Pony AIO Fpv cam for it. None of the available models had features I wanted or fit properly to this tiny AIO cam. So I set out to start learning Blender and tried to make my own mount. This is the end result of this very story. The camera position is as centralized as I could get, with approximately a 10-degree cam angle. As well has having under-board supports, the cam cut out and walls are all fitted snugly now. This has a Single loop roll bar for the "whip" antenna that comes on these cams. I'm not sure if it will thread through/fit around a clover. On the sides of the mount, are two ports. With a small hot glue gun, you can push in a small amount of glue and secure the cam and roll cage. I hope people get some use out of this mount, it has been fun making it and beginning to learn this process. Any pointers or tips or comments about the mount are welcome! Thanks for checking out my project! Print Settings Printer: MOD-t Post-Printing Generations