AIO FPV Mount

thingiverse

Hi All! Here is my 25mw 40ch AIO FPV Mount. Easy to print and very light. It has 2 tabs underneath which you can drill 2.5mm holes in the desired place to mount onto the cheap FPV camera mounts (or onto the mounts I have made) When printing I recommend using a raft and supports and to print it on its back. To mount the camera, Simply place the camera in the cradle and use a small cable tie or on of those wire fasteners to get in packaging (make sure its a plastic coated one!), route it between the camera and transmitter boards and then wrap it underneath the cradle and tighten. be sure not to tighten to much as it may damage the boards, it only needs to be tight enough so the camera doesn't move. Comments and advice welcome!! :)