Air Zone Punisher - 43mm Cage (Airzone)

thingiverse

This is a 43mm flywheel cage for the Airzone Punisher. Its a remix of the OFP 43mm Stryfe cage. You wont need the back plate used on the original to hold the motors in as this design uses the motor screw holes on the face. Iv also added reinforcement to keep it rigid without the backplate (see last image) Due to the required rigidity you will need to print it with a high infill to prevent it from bending under load. I personally used 100% at 0.1mm with the two towers facing the print bed. Supports will be needed but touching the bed only This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/hmH22GYpzpZ