Airboat v2

thingiverse

Airboat v2 is a near total rework of my first airboat design. This version requires a bit more support while printing the cowling however this design is much more serviceable in that the servo no longer needs to be glued into the rudder and the cable for the servo is in a better position so that it doesn't get sucked into the fan... The motor also sits slightly higher in this version to help keep the fan above water. The electronics are all the same, those being a generic 9 gram servo, 30a drone esc, br2212 1400kv racerstar motor, 3s lipo battery, and a flysky fs-ia6b reciever. other bits are 7 m4 bolts nuts and washers as well as a pair of m2 bolts for the motor.