Airsoft bullpup ak

thingiverse

I bet you saw the evike scar 3d printed bullpup conversion kit. or even their expensive limited time bullpup AK. Well, if you didn't at least I did; so I decided to combine the two to make a fully 3d printed airsoft AK conversion kit. before you get too far I based it off of an AK you can get in dick's or evike, I'm not sure if it will work with all AK's. the link to the gun is here: --> http://www.evike.com/products/48013/ Now, there are some things you will need for this to work as best as possible: first, you will need to shorten the charging handle rod by 11mm to fit the design. then you will ned theses parts from evike:http://www.evike.com/products/47380/http://www.evike.com/products/46901/ and I highly suggest a mag with a smaller curve such as this one: http://www.evike.com/products/63737/ the rail has to be wide so if there are any attachments that slide on you might have to file down the sides of the rail. the trigger is in an awkward location, but it works and you will adapt to it quickly.